decon E-Drive PLUS Service Manual page 36

Assistant Controller Installation Position Adjustment
4 Brake Cable Connection
1 Insert the cable joint into the brake
lever hole.
2 Place the brake cable end in the
cable joint hole.
3 Place the outer portion of the brake
cable in the lever holder hole.
4
36
Required tools: 5 mm hexagon wrench
T h e h e i g h t a n d a n g l e o f t h e
controller c an b e change d by
loosening the adjustment bolt
(see diagram below).
End
Cable joint
Cable joint
Brake lever
End
Adjustment bolt
Lever holder
Brake cable