Table of Contents
Advertisement
3.5. Anti-tip Device Adjustment
Adjust the anti-tip device so that the front casters are not more than 10 cm off the ground when
the anti-tip device contacts the ground.
(1)
Anti-tip Device Length Adjustment
The 16" model can be adjusted to 2 lengths and
the 20", 22", and 24" models can be adjusted
to 3 lengths.
1
Remove the bolt that secures the anti-tip
device.
2
While checking the front caster height
when the anti-tip device contacts the
ground, select the appropriate mounting
hole.
3
Install the bolt.
Tightening torque: 4 to 6 Nm
(2)
Anti-tip Device Angle Adjustment (Adjustable
to 3 Angles)
Anti-tip Device Installation Angle Adjustment
1
Remove the clamps that are securing the
lead wire.
2
Remove the bolts and nuts.
3
Select the mounting holes for the bolts
to adjust the angle of the anti-tip device.
Make sure that the lead wire is not pulled.
4
After inserting the bolts in the holes, tight-
en the bolts and nuts while pushing the
anti-tip device upward.
Tightening torque: 6 to 8 Nm
5
Secure the lead wire so that it will not con-
tact the wheels or other parts.
3
31
Advertisement
Table of Contents
