Table of Contents
Advertisement
Purpose of Operation
[Joystick Input Direction
Selection]
Set whether the wheelchair
moves in the same
direction or the opposite
direction of the joystick
[14]
input direction.
This setting is a special
operation method for users
who use a chin controller,
and so on. Normally, do not
use this setting.
[Write]
[15]
6
Write the selected settings
to memory.
[Restart]
[16]
Use the wheelchair with the
saved settings.
72
Operation Method
If the desired parameter is blinking,
the following operation is not
necessary.
If a different parameter is blinking,
briefly flip the speed switch up or
down until the desired parameter is
blinking.
The buzzer sounds briefly only when
a setting has been changed.
You can redo this as many times as
Speed switch
you wish.
Briefly tilt forward
once.
Hold down the speed switch for 2
seconds (until the buzzer beeps).
At this time, you will hear a long
buzzer.
Once the buzzer beeps, release
your hand from the switch.
The settings are saved.
If you turn off the power without
performing this operation, the
Speed switch
settings will not be changed.
Turn off the power, and then turn it
back on. You will hear a short
buzzer.
This is the same as when the power
is normally turned on.
You can now use the wheelchair with
the modified settings.
Parameter Status during Operation
and Its Meaning
Standard
Front/back reversed
Left/right reversed
Front/back and
left/right reversed
Briefly tilt toward
you once.
Writing timing indication
Writing complete
Advertisement
Table of Contents
