decon E-Drive PLUS Service Manual page 25

3
Adjust the installation position.
Adjust the controller to a position that is easiest to operate by taking the height,
angle, and its distance to the arm support into consideration.
Adjusting the Installation Position of the Controller (Part 2)
Hand rest plate
Removal of the Controller
For example, when the customer wants to sit close to a table, the controller can be
detached with moving the under holder locking lever.
Do not remove the controller from the under holder while the power is switched ON.
Once you remove the controller from the under holder, do not switch the power ON.
The control lever may tilt to cause the wheelchair to move unexpectedly, and you
or other people around you may get injured.
In addition, if you removed the retaining bolt, you can use the supplied hand-tight-
ened screw.
Required tools: 5 mm hexagon wrench
• Adjust the height so that the punch mark (ad-
justment limit punch mark) remains hidden.
Height-adjusting bolt
Tightening torque: 14 to 16 Nm
Switching the hand rest plate to the left- or
Maximum 60 mm
right-hand side
On the left-hand drive model, remove the hand
Punch mark
rest plate by pulling it upward, change the rub-
ber plate direction and relocate it to the left.
WARNING
3
25