Table of Contents
Advertisement
(2)
Installation
Install using the reverse order of the removal
procedure. Before installation, check that the
heat dissipation sheet (also acts as an insula-
tor sheet) is neatly applied on the motor control
unit.
1
Install the motor control unit (circuit board)
to the drive unit, and tighten the 3 screws
evenly to the specified tightening torque.
Using the spring and spacers, secure the
heat sink plate with the 2 screws.
Tightening torque: 0.4 to 0.6 Nm
2
Connect the connectors in their original
locations.
3
Install the O ring and plastic transmission
cover, making sure that the lead wires do
not get pinched.
Tightening torque: 1.5 to 2.5 Nm
4
Install the wheel assembly according to the
instructions in section (2) in 5.1.
Heat dissipation
sheet
W
R
B
R : Red cable line
W : White cable line
B : Black cable line
R
B
5
49
Advertisement
Table of Contents
