decon E-Drive PLUS Service Manual page 26

(3) Swing Out Bracket
1
Fit bar 1 into the pipe. Make sure that bar 1
is installed in the correct direction.
Install the holder, and then tighten the bolt.
Front (25 mm)
Tightening torque: 6 to 8 Nm
Rear (40 mm or 45 mm)
Tightening torque: 2 to 3 Nm
2
Install the upper holder assembly to the
holder and temporarily tighten it.
3
3
Install the upper holder assembly to the
controller and temporarily tighten it.
26