Advertisement
Quick Links
Advertisement
Related Manuals for decon ADV5X02
Summary of Contents for decon ADV5X02
- Page 1 2021-03-08 Revision 2...
- Page 2 Adjustment of the Adventus wheel is described in the user manual of the Adventus wheel. Assembly work or changes made to the mounting set must be carried out by trained service technician, reseller or another person assigned by Decon. __________________________________________________________________________________...
- Page 3 Assembly Instructions ADV5 Adventus adaptor bar Universal __________________________________________________________________________________ A Adapterbar B Fork adapterbar C Adapterkit D QR pin The adapterkit (C) can vary depending on the tube size of the chassis and might not match the one in the picture above. These assembly instructions shows the adaperkit (C) mounted in the lower pipes of the wheelchair.
- Page 4 Assembly Instructions ADV5 Adventus adaptor bar Universal __________________________________________________________________________________ First mount the Adapterkit (C). Mount the holders so that they still can be moved along the wheelchair chassis The distance X should not be greater than 20mm to ensure that the bar gets sufficient support.
- Page 5 Assembly Instructions ADV5 Adventus adaptor bar Universal __________________________________________________________________________________ Mount the adaptorbar (A) into the holders and lock it into place using the QR Pins (D). Now tighten the screws sitting in the clamps that connects to the frame of the wheelchair. After the screws are tightened check that the adaptor bar still can be removed from its holders without excessive force.
- Page 6 Assembly Instructions ADV5 Adventus adaptor bar Universal __________________________________________________________________________________ Mount the fork onto the adaptor bar. Mount the adjustment toll onto the fork (B). Remove the screws in the fork that locks the rotation (see picture bellow). Also make sure that the fork sits in the center of the wheelchair.
- Page 7 Assembly Instructions ADV5 Adventus adaptor bar Universal __________________________________________________________________________________ Now rotate both the adapter bar and the fork to a position where the adjustment tool shows the correct angle and the fork doesn’t collide with the footrests. If possible, make sure that the fork doesn’t sit lower than the footrest and that the height, if possible, corresponds to the picture bellow.
- Page 8 Assembly Instructions ADV5 Adventus adaptor bar Universal __________________________________________________________________________________ Reassemble the screw in the hole that is fits the best, see picture bellow for example. __________________________________________________________________________________ Sida 8/10...
- Page 9 Also make sure one last time that the fork is centered and the angle of the adjustment tool is still correct. Check one last time that all screws are properly secured. Now see the user manual of Adventus to continue the installation. This can be downloaded from www.decon.se/en/ __________________________________________________________________________________ Sida 9/10...
- Page 10 Decon Wheel AB Södra Ekeryd 119, SE-314 93 Hyltebruk, Sweden Tel: +46 (0)345 40880 Fax: +46 (0)345 40895 E-mail: info@decon.se...