decon E-Drive PLUS Service Manual page 20

3.2.3. Installation for E-Drive PLUS 16" Fixed Axle Model (When Using Bracket B)
When using bracket B to install the power unit to the wheelchair frame, be sure to
leave the O rings and washers attached to the axle. If the O rings and washers are
removed, the power unit will be damaged.
Required tools:
Leave the washers and O rings attached to the axle during installation.
Note
(1) Right Drive Unit Installation
1
Temporarily tighten bracket B for the right
3 unit to the back pipe using the frame axle
hole. Align the holes in the plate and boss
and tighten sufficiently to remove any
looseness.
2
Temporarily tighten the drive unit using the
mounting nut. The nut is temporarily tight-
ened to prevent the drive unit from falling;
therefore, do not tighten the nut forcefully.
3
Fully tighten the nut that was temporarily
tightened to the frame axle hole.
Tightening torque: 40 to 50 Nm
4
Fit the projections on the back of the drive
unit into the slots in bracket B, and then
fully tighten the axle.
Tightening torque: 40 to 50 Nm
5
Fully tighten the bolt.
Tightening torque: 14 to 16 Nm
20
17 mm socket, socket wrench, torque wrench, 17×19
mm open-end wrench, and 5 mm hexagon wrench
NOTICE
Bracket B
Washer and O ring
Frame
pipe
Frame pipe
Adjusting holes