decon E-Drive PLUS Service Manual page 35

4.1.2. Installation
If the battery box interferes with the wheelchair frame or other parts when the reclining or tilting
functions are used or the arm supports are flipped up, the position of the battery seat can be
changed to prevent the interference.
1 Remove bolts a, b, c, and d.
(Do not reuse the removed bolts.)
2 Using the spacers and bolts from the "Bat-
tery Seat Offset Installation Parts (Option-
al)", insert spacers between the battery seat
and the anti-tip device mounting plate, and
tighten the bolts to secure the battery seat.
Tightening torque: 9 to 11 Nm
For bolt a, use the 40 mm (65 mm) flange
bolt.
For bolts b, c, and d, use the 45 mm (70
mm) flange bolts.
3 Place the controller fully over the hand grip pipe.
Tighten the screw so that the brake lever faces
straight down.
Required tools:
If the inner diameter of the pipe is small,
replace the nut lock.
Ensure that at least 40 mm is inserted.
Also note that if it is inserted as far as it will
go, it may come in contact with the shoul-
ders and head of the individual sitting in the
wheelchair.
5 mm hexagon wrench and
torque wrench
d
a
c
b
d
a
c
b
Screw
Brake lever
Tightening torque: 11 to 13 Nm
<Assistant Controller>
4
35