5.6. Clutch Switch Adjustment
Be sure to perform the following adjustment
after replacing the clutch switch or shift plate 1.
Disconnec t the clutch switch coupler and
connect it to a tester.
When dimension A (the distance bet ween
shift plate 1 and the seal plate) is changed,
the continuity of the clutch switch should be
as shown in the following table. Loosen the
screw, adjust the position of the adjuster plate,
and tighten the screw.
(A s you ch e ck f o r continuit y, n o chan g es
should occur when you shake shift plate 1 in
the direction of the wobble shown to the right.)
Dimension A
3.5 mm
4.5 mm
5.7.
Controller Removal, Installation, and Position Adjustment
5.7.1. Standard
(1)
Removal
1
Loosen the 4 bolts indicated by the arrows.
2
Remove the controller.
5
(2)
Installation
1
Set the controller onto the upper holder.
2
Tighten the 4 bolts evenly.
Tightening torque: 6 to 8 Nm
52
Clutch Switch Continuity
Yes
No
Upper holder