decon E-Drive PLUS Service Manual page 45

When inserting the screwdrivers, be careful not to scratch or damage the visible
parts of the hub (aluminum portion). Lift up the handles of the screwdrivers so that
the screwdrivers do not scratch the visible portions of the hub.
The standard wheel caps are affixed strongly. Perform the work with sufficient care
to ensure that you do not scratch the visible portions or injure yourself.
(2) Cleaning of Affixing Surfaces
1
Remove the remaining double-sided tape
with a scraper or similar tool.
Be careful that alcohol or tape does not
enter the hub through the open holes in the
hub.
2
Remove any grease from the affixing sur-
face with alcohol or a similar substance.
When cleaning the wheelchair, do not use an organic solvent. Wipe the wheelchair
using a towel that has been wrung out. If the dirt is difficult to remove, use neutral
detergent and wipe the wheelchair. Because water could enter the power unit, do not
clean the wheelchair by spraying or splashing water on it.
(3) Wheel Cap Affixing
Affix the wheel caps according to the instructions in "3.7. Wheel Cap Installation (20", 22"
and 24" Models)".
NOTICE
Scraper
NOTICE
4
45