Table of Contents
Advertisement
Purpose of Operation
[Electromagnetic Brake
Operation Timing
Selection]
Select whether the
[6]
electromagnetic brake is
applied immediately after
the wheelchair stops or 10
seconds after the wheel-
chair stops.
[JW Smart Tune Cable
Insertion]
Select whether the
[7]
wheelchair stops or a notifi-
cation is displayed on the
LCD when the JW Smart
Tune cable is connected.
Operation Method
If the desired parameter is blinking,
the following operation is not
necessary.
If a different parameter is blinking,
briefly flip the speed switch up (or
down) once while the parameter is
blinking until the desired parameter
is blinking.
The buzzer sounds briefly only when
a setting has been changed.
Speed switch
You can redo this as many times as
you wish.
Briefly tilt forward
once.
If the desired parameter is blinking,
the following operation is not
necessary.
If a different parameter is blinking,
briefly flip the speed switch up (or
down) once while the parameter is
blinking until the desired parameter
is blinking.
The buzzer sounds briefly only when
a setting has been changed.
Speed switch
You can redo this as many times as
you wish.
Briefly tilt forward
once.
Parameter Status during Operation
and Its Meaning
10 seconds after stopping
(default setting)
Immediately after stopping
Briefly tilt toward
you once.
Stop (default setting)
Notification only
Briefly tilt toward
you once.
6
75
Advertisement
Table of Contents
