Power Switch And Speed Switch Replacement - decon E-Drive PLUS Service Manual

4.3. Power Switch and Speed Switch Replacement

4.3.1. Toggle Switch Removal
1
Remove the battery.
2
Turn on the power switch, and then turn it off
again after approximately 1 second. (This dis-
charges any residual electricity held in the ca-
pacitors, etc., on the printed circuit board.)
3
Remove the 6 screws from the under cover of
the switch case.
4
Disconnect the 3 connectors on the printed
circuit board that are connecting the lead wires
from the under cover of the switch case.
5
Disconnect the connector on the printed circuit
board that is connecting the lead wire from the
toggle switch.
6
Loosen the cap with an open-end wrench and
remove it.
7
Loosen the nut with an open-end wrench, re-
move it, and then remove the toggle switch from
the case.
8 Repeat steps 5 – 7 to remove the other toggle
switch.
Connectors
Under cover
Toggle switches
4
41