Table of Contents
Advertisement
Purpose of Operation
[Battery Residual
Capacity Display]
Set the display method for
the battery.
[8]
When using the black lithium ion battery:
Select one of the following display patterns.
Pattern 1 Display
Pattern 2 Display
When using the nickel metal hydride battery or the gray lithium ion battery:
The display pattern cannot be selected. The following display pattern (20% increments) will be used even if you select pattern 1 or pattern 2.
[Write]
[9]
Write the selected settings
6
to memory.
[Restart]
[10]
Use the wheelchair with the
saved settings.
76
Operation Method
If the desired parameter is blinking,
the following operation is not
necessary.
If a different parameter is blinking,
briefly flip the speed switch up (or
down) once while the parameter is
blinking until the desired parameter
is blinking.
The buzzer sounds briefly only when
a setting has been changed.
Speed switch
You can redo this as many times as
you wish.
5% increments
Briefly tilt forward
once.
In the writing screen, hold down the
speed switch for 2 seconds (until
the buzzer beeps).
At this time, you will hear a long
buzzer.
Once the buzzer beeps, release
your hand from the switch.
The settings are saved.
If you turn off the power without
performing this operation, the
Speed switch
settings will not be changed.
Turn off the power, and then turn it
back on. You will hear a short
buzzer.
This is the same as when the power
is normally turned on.
You can now use the wheelchair with
the modified settings.
Parameter Status during Operation
and Its Meaning
Pattern 1 (default setting)
Pattern 2
5% increments
Briefly tilt toward
you once.
Writing screen
Writing complete
Advertisement
Table of Contents
