Table of Contents
Advertisement
5
Remove the bolt securing the holder, and
remove the bar from the arm support pipe.
6
Remove blind plug 1 from the arm support
pipe where the controller will be installed,
and remove the bolt.
7
Install blind plug 1 and the bolt to the arm
support on the opposite side of the wheel-
chair.
8
Fit bar 1 into the arm support pipe where
the controller will be installed (make sure
that bar 1 is installed in the correct direc-
tion), and secure the slider with the bolt.
Front (25 mm)
5
Bolt tightening torque: 6 to 8 Nm
Rear (40 mm or 45 mm)
Bolt tightening torque: 2 to 3 Nm
9
Install the slider with the controller to the
holder.
Bolt tightening torque: 6 to 8 Nm
:
Route the lead wires and secure them with
clamps. Route the lead wires with enough
slack so that they will not be pulled when
the frame is folded or the arm support is
flipped up, and they will not be pinched by
the crossbars or other movable parts.
A
Bundle the excess lead wires and store
them in the battery box. Install the cover.
Plate cover bolt tightening torque:
1.5 to 2.5 Nm
56
Hole
Rear
Thread
Front
Clamp
Advertisement
Table of Contents
