Table of Contents
Advertisement
(5)
Wire Routing for Left-Side Installation of Control-
ler
1
With the controller installed on the left side
of the wheelchair, route the lead wires from
below the under holder toward the battery
seat. Route the lead wires along the frame
and crossbars, securing the lead wires at 5
to 10 cm intervals. (See diagram at right.)
2
When routing the lead wires along the base
pipe, route them on top of the pipe and
secure them.
3
When routing the lead wires along the
crossbars, route the leads so that they will
not be pinched by the pipes, be pulled, or
become twisted or slack when the wheel-
chair is folded.
4
Use wire cutters or a similar tool to cut
off the excess ends of clamps so that the
3
ends do not protrude.
5
Connect the control unit according to the
instructions in "(8) Connecting the Control
Unit and Lead Wires" in 3.4.
(6)
Wire Harness Routing for the Lef t Drive Unit
(20", 22", and 24" Models)
1
Route the wire harness so that it forms
an upward arch and adjust the length of
the harness so that it will not be pulled
or become too slack. (If the wire harness
is hanging down, it can easily become
caught, causing a malfunction.)
2
Adjust the position of the arched portion of
the wire harness so that any items will not
rest on top of the wire harness. If neces-
sary, use the 2 large clamps and 2 small
clamps that are supplied to secure the wire
harness.
28
Tie straps
Tie straps
Tie straps
Crossbars
(Bottom view)
(Fixed Axle Model Sample)
Tie straps
Tie straps
Advertisement
Table of Contents
