Table of Contents
Advertisement
3.6. Clutch Lever Position Adjustment
On the 20", 22" and 24" models, if the clutch lever interferes with the operation of the parking
brake lever or other parts, the length and angle of the clutch lever can be adjusted.
(1)
Angle Adjustment
1
Remove nut "a" and loosen the bolt.
2
Fit the projection on lever "c" into an ap-
propriate hole in lever "b" to adjust the
position of lever "b".
3
Tighten the bolt and nut.
(2)
Length Adjustment
The total length of the clutch lever can be ad-
justed to 2 lengths by installing the lever in either
of the 2 mounting holes.
1
Remove nut "a" and the bolt.
2
Select the appropriate mounting hole and
tighten the bolt and nut for adjusting the
3
lever angle according to the instructions in
section (1) in 3.6.
Bolt tightening torque: 10 to 12 Nm
Nut tightening torque: 6 to 8 Nm
3.7.
Wheel Cap Installation (20", 22" and 24" Models)
Peel off the film from the double-sided tape on the
back of the wheel cap.
Position the wheel cap so that it will not cover ring
2 or the cap, and install it to the hub.
Push the wheel cap so that the double-sided tape
is affixed securely.
32
a
b
c
Example showing 5 adjustments
Advertisement
Table of Contents
