4.9 Disabling stacker motion
Step # Description
1
Disable stacker
motion.
2
Reinstate stacker
motion.
4.10 Collator speed adjustment
Step # Description
1
Enter speed
adjustment mode.
2
Select collating
speed.
3
Confirm adjustment.
4.11 Disengaging bins with defective sensors*
Step # Description
1
Isolate defective bin
sensors and
disengage these
bins.
2
Re-engage bins after
correction of the
problem.
This process can also be used to disengage bins with other problems. In this
*
case the feed roller shaft is removed and a sheet inserted (80 gsm or heavier) in
the bin to cover the bin sensor (simulating a defective sensor). Pressing "Test/
calibration" for more than five (5) seconds will now disengage this bin.
Action
Press and hold down "Straight/offset
stacking" for more than two (2)
seconds.
Press and release "Straight/offset
stacking".
Action
Press and hold "Selection
programming mode" for more than two
(2) seconds.
Press "Selection programming mode".
Press and hold "Selection
programming mode" for more than two
(2) seconds (the bin LED will go out).
Action
Press and hold "Test and calibration"
for more than five (5) seconds.
Press and hold "Test and calibration"
for more than five (5) seconds.
11
Operation
Notes
For handling of
extreme light weight
papers.
Notes
The last bin LED
lights and counter
display shows speed
in sets/h :10
The counter will
display the speed in
sets/h :10
The counter will now
display the counter
value.
Notes
The electronics check
all bin sensors and
disengages the bins
with defective sensors.