Toilet; Operating Instructions - Holiday Navigator 2003 Owner's Manual

The toilet uses water from either the fresh water
tank or a city water supply. The water pump must
be turned on or connect the motorhome to city
water. The toilet uses 12 Volt DC to flush. The toilet
flushes directly into the sewage holding tank (black
water).
• To add water to the toilet, lift the flush lever
until the desired water level is obtained.
Generally, more water is required when
flushing solids.
• To flush the toilet, momentarily push the lever
down. Holding the lever down will not
increase flush time or water flow. The flush
cycle is a timed event controlled by a micro-
processor. Water pressure and flow rates vary
with locations. It may be necessary to adjust
the water level.
NOTE: The toilet requires 12 Volt DC to operate. Low
voltage will cause toilet malfunction or failure.
Control switches:
Under the lid are two switches.
• The Water Level switch adjusts the water level in the
bowl after the flush cycle.
• The Function switch will reset the microprocessor or
hold the ball valve open.
Water Level Switch:
This switch adjusts the water level in the bowl after the flush cycle.
NOTE: Setting the switch to High increases water consumption
and water spill may occur during travel.
Function Switch:
• Pushing the switch to Service will hold the ball valve open. This feature
is useful when adding chemical to the sewage tank.
NOTE: Most chemical mixtures for holding tank odor control
are poisonous. Follow the product manufacturer's directions
and warnings when using any holding tank additive.
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
N A V I G A T O R 2 0 0 3
Water Systems

TOILET

-

Operating Instructions

6 • 2 4 7
040449b
040449b