Water Systems Introduction; Measurement & Calibration (Water Tanks); Monitor Panel - Holiday Navigator 2003 Owner's Manual

Table of Contents

Advertisement

This section contains information about the operation and care of the various
water system equipment found in the motorhome. The motorhome is equipped
with two separate water systems. Optional water equipment will also be discussed,
so not all information may be applicable to the motorhome. More detailed
information with CAUTION or WARNING instructions for the various
equipment, other than what is found in this section, can be found in the
manufacturer's manual in the owner information box.
It is hard to imagine how much water is used by the average person everyday.
Newcomers to a self-contained motorhome soon discover water does not last
very long unless consumption is drastically reduced. For example, less water
can be used for showering if the shower is turned off while soaping down, then
turned back on to rinse. This way a good shower uses a couple gallons of
water or less. There is plenty of water to meet personal needs once habits are
adjusted.
Fresh Water System:
The fresh water system consists of the fresh water tank, water pump, gravity
fill connection, water filter and a city/fresh water connection. Use a water hose
that is marked for potable water use only. Care of the hose is a must. After
each use, drain the water hose and coil the hose neatly. Attach the ends
together to keep debris and insects out of the hose.
Waste Water System:
The waste water system consists of a waste holding tank (grey water), a
sewage holding tank (black water), flush system, toilet and drains.
The monitor panel includes a
combination gauge that reads all water
holding tanks (fresh, grey and black).
Tank Measurement:
To measure the level of any holding
tank, push the switch on the monitor
panel corresponding with the tank to be
measured.
NOTE: If the domestic batteries are not at a full state of
charge tank readings will not be accurate.
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
N A V I G A T O R 2 0 0 3
Measurement & Calibration (Water Tanks)
Water Systems
WATER SYSTEMS
INTRODUCTION
040400
Screw the ends of the hose
together before storage to pre-
vent leakage and to prevent dust
and insects from entering hose.

MONITOR PANEL

020088
6 • 2 3 1

Advertisement

Table of Contents
loading

Table of Contents