Maintenance & Lubrication; Tips - Holiday Navigator 2003 Owner's Manual

Equipment
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Tips

Maintenance & Lubrication
5 • 1 7 8
If the step fails to operate:
• Verify that the step switch is ON.
• Check the main power supply for the step, a 20 Amp circuit breaker
located on the low current plate.
• A magnetic door jam switch is used to control step operation. Use
a separate magnet to apply a "trigger" to the door jam switch.
Rotate test magnet to align polarity field.
• A 7 ½ Amp ATO blade fuse is used to illuminate the STEP OUT
dash warning light. The fuse is located on the front run box.
WARNING: If the motorhome is driven with the step in the
extended position there is the possibility of causing major
damage to both the step and the motorhome.
NOTE: Silicone lubricates and WD-40 are
not recommended as they have a tendency to
evaporate and dry the mating surfaces which
leaves them vulnerable to the elements.
entry step
N A V I G A T O R 2 0 0 3
Clean all mud, salt and
road grime from the step
before lubricating.
Lubricate all moving parts
(bearings, pivot points,
slides, clevis pin and the
drive linkage ball) every
30 days with a good quality
heat and moisture resistant
penetrating grease. Kwik
Lube Spray Grease is
specially formulated to
lubricate Kwikee Electric
Steps and it is also recom-
mended for lubricating all
moving parts. (Refer to the
illustration.)