Holiday Navigator 2003 Owner's Manual page 199

To Retract the Awning:
• Remove the wind braces.
• Verify all persons and objects are clear from the retract
path of the awning and related hardware.
• Turn the One Touch key to the ON position.
• Press and hold the momentary switch to RETRACT.
The motor will automatically stop at full retraction.
• It takes approximately 14 seconds for the awning to
travel from the fully extended position to the fully
retracted position.
• Turn the One Touch key to the OFF position to avoid
accidental deployment of the awning while the vehicle
is in motion.
Tips - If the awning fails to retract or extend:
• Verify the One Touch key is in the ON position.
• The house battery cut off switch is in the ON position.
• The house battery voltage is at 12 Volts or above.
• Verify proper electrical connection from the awning
motor to the side of the motorhome.
Emergency Retract Procedure:
If the One Touch awning fails to retract and proper DC voltages have been
verified, the One Touch awning has two emergency methods of alternately
retracting the awning.
1. Two exposed electrical studs are mounted externally at the forward
end of the awning at the motor assembly. An alternate 12 Volt DC
positive and negative supply may be applied to these connections.
If awning fails to move, reverse the polarity of the alternate supply
leads.
2. On the motor assembly, mounted externally at the forward end of
the awning, is an opening. Insert a 9/64" Allen hex wrench. Using
an electric drill, wind the awning to the retract position.
CAUTION: When using an alternate method to operate the
awning, use extreme care to keep appendages, hair or loose
clothing away from exposed rotating hardware.
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
N A V I G A T O R 2 0 0 3
Electric
Studs
Insert the 9/64" Allen
Hex Wrench here.
12 Volt Motor.
Equipment
030822
5 • 1 9 9