Oil Lube Intervals - Holiday Navigator 2003 Owner's Manual

Chassis Information
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Oil Lube Intervals

1 0 • 4 0 6
To inspect the oil level:
• Remove the chrome hubcap.
• Locate the full and add mark on the outside of the clear plastic cover.
• If the lubricant level is low, add the recommended fluid until full.
The recommended oil change interval is based on the operating conditions,
speeds and loads. Limited service applications may allow the recommended
interval to be increased. Severe applications may require the recommended
interval to be reduced. For more information, contact a Dana/Eaton service
representative.
Recommended Interval Change:
• Change the fluid whenever the seals are replaced, the brakes are
relined or at 30,000 miles (48,000km). However, check the
lubricant twice a year (spring and fall) for contamination. Change
as needed.
• If yearly mileage is less than 30,000 miles, change the fluid twice
a year (spring and fall).
Lubricant Type:
• Shell Hypoid gear oil, GL-5, S.A.E. 80w/90. Specifications,
minimum ambient temperature - 15º F (-26.1º C). There is no
maximum ambient temperature. Lubricant temperature must never
exceed 250º F (+121º C).
To Drain:
• Place a suitable container below the bearing cover and remove the
drain plug. If the cover does not have a drain plug, remove the
screws retaining the cover plate to drain the lubricant.
• Replace plug or cover plate and fill bearing assembly with the
recommended lubricant.
N A V I G A T O R 2 0 0 3
090311
090312