Retracting Main Room(S) - Holiday Navigator 2003 Owner's Manual

Table of Contents

Advertisement

Equipment
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Retracting Main
Room(s)
5 • 1 8 6
To Retract the Slide-Out Room:
• Check for sufficient clearance inside the motorhome before
retracting the slide-out room.
• Clean the floor to ensure there is no dirt or grit that could result in
floor damage during operation.
• Move the driver seat forward.
• Inspect the exterior to ensure all bay doors are closed and there
are no sags in the awning material.
• Remove any debris from the top of the slide-out room.
• Prior to retracting the slide-out room, start the motorhome. Allow
the air bags to fully inflate to normal travel height.
• Retract the leveling system or prepare the air leveling system for
travel prior to operating the slide-out.
• Turn the ignition switch OFF. The slide-out room will not operate
with the engine running.
• The house batteries are fully charged.
• The park brake must be applied.
• Ensure all people, pets and objects are clear of the slide-out room
path.
• Press and hold the switch in the IN position. The slide-out room
will move slowly in. To stop the slide-out room, release the
switch. To continue the room movement, push and hold the switch
in. The motor will change tone when the slide-out room is fully
retracted.
• Release the switch.
NOTE: Be sure you have sufficient clearance on the inside of the
motorhome (driver seat, etc.) before you retract the slide-out room.
If the motorhome has ceramic tile floor ensure the floor is clean
before you retract the slide-out room. Trapped dirt or grit under the
slide-out room can scratch the floor surface. Never move the
motorhome with the slide-out room extended.
CAUTION: Rain water can pool on the slide-out awning. The added
weight will cause the awning to sag. Upon retracting the room,
material can become caught in between the top of slide room and
the opening in the motorhome. It will be necessary to retract the
room in small increments allowing the water time to run off.
N A V I G A T O R 2 0 0 3

Advertisement

Table of Contents
loading

Table of Contents