Holiday Navigator 2003 Owner's Manual page 354

Electrical Systems - Chassis
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
090270
9 • 3 5 4
MARKER LAMP FLASH:
When the headlights are ON, pressing the switch causes the taillights
and all marker lights to go off as long as the switch is pressed.
Similarly, when the headlights are OFF, pressing the switch causes
the headlights to illuminate as long as the switch is pressed.
WIPER OFF:
Cancels all wiper operations. Any time the ignition is off this mode
goes active.
WIPER LO/HI:
Initially causes the Low Speed Wiper function to activate. If the
switch is pressed, again the High-Speed Wiper function will be
activated. Subsequent presses of this switch will cause alternate
operation of the wipers in the low or high-speed mode.
WIPER WASH:
Activates the wash pump relay while the switch is pressed.
Additionally, if none of the latching wiper functions (Wiper Lo/Hi
or Variable) had been previously selected, the Low Speed Wiper will
be activated for a period of approximately three wiper cycles after
the switch is released. If any of the latching wiper functions (Wiper
Lo/Hi or Variable) had been previously selected, the wipers will
continue to run in the selected mode after the wash switch is
released.
WIPER VARIABLE:
Operation of the WIPER VARIABLE switch causes the Low Speed
Wiper function to activate for one wipe. If the switch is pressed again
within approximately 30 seconds, the Low Speed Wiper function
activates again and repeats at an interval determined by the time
between the last two operations of the switch. Additional switch
operations will shorten the cycle. Activation of any other wiper mode
cancels the variable mode. The effect for the driver is this: In light
rain or mist conditions, the driver presses the switch once when the
windshield first needs clearing. When the windshield requires clearing
for the second time, the driver presses the button again setting the
timed interval between subsequent wipes required by the current
conditions. To extend the wipe interval, switch the wipers off then
use the same method to set the desired interval.
N A V I G A T O R 2 0 0 3