Navigation System - Holiday Navigator 2003 Owner's Manual

The navigation system uses a seven-disc map library to operate. The library
is located in the owner's information packet. The system remote control is
used to program settings and retrieve information. Only areas that are high-
lighted are accessible. A planned destination, point of interest from the virtual
map and an alternate route may be programmed. When a destination has been
programmed, it may be necessary to change map discs while in route. An
audio voice will provide instructions.
NOTE: Thoroughly read all of the following instructions
before attempting to program the navigation system. These
instructions are a simple guide to some of the features. It is
not a replacement for the system manual. It may be easier to
have a partner read the instructions while programming the
system.
Before beginning navigation system programming, ensure the radio screen
is programmed to display the navigation system.
• With the monitor ON, enter the radio
programming mode by pressing the
Menu button for two seconds.
• Under the USER section scroll up or
down to the NAVI IN section. Press
ENTER.
• Using the LEFT or RIGHT buttons
move the hand cursor to VTR. Press
ENTER to select. Selection will be
highlighted in yellow.
• Press Menu to exit programming
mode.
• The navigation system may now be
viewed.
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
N A V I G A T O R 2 0 0 3

Navigation System

020099
Equipment
020121
020122
5 • 2 0 9