Smart Wheel Operation; Wiper Function - Holiday Navigator 2003 Owner's Manual

Functions and an operational description for the smart wheel are as follows:
HORN:
The horn bar on the steering wheel will send the appropriate
signal to the Master Controller causing the HORN output to be active
while the switch is pressed.
HEADLAMP FLASH:
This function is the ICC (Interstate Commerce Commission) courtesy lamp.
When the headlights are ON, pressing the switch causes them to go off as
long as the switch is pressed. Similarly, when the headlamps are OFF,
pressing the switch causes them to illuminate as long as the switch is
pressed.
CRUISE FUNCTIONS:
• CRUISE CANCEL - Signals the cruise system to disengage without
losing the current speed memory setting.
• CRUISE ON/OFF - Cycles the Cruise system ON and OFF.
• CRUISE RESUME - Actuates the Cruise Resume function of the
engine controller.
• CRUISE SET - Actuates the Cruise Set function of the engine
controller.
WARNING: Do not use cruise control in heavy traffic or on
roads that are winding, slippery or unpaved. Do not shift the
transmission into "N" (Neutral) with the cruise control on as
high engine RPM run up will occur until the cruise control is
turned off.
The wiper control circuitry synchronizes both wiper motors. For that reason
the faster wiper will pause at the end of each cycle and wait for the slower
wiper to complete its cycle before resuming.
Any wiper function activation generates a "Headlamp On" signal from the
Master Controller. This will only reset by turning off the ignition or by activating
then deactivating the dashboard headlamp switch.
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
N A V I G A T O R 2 0 0 3
Electrical Systems - Chassis
Smart Wheel
Operation

Wiper Function

9 • 3 5 3
090270