Holiday Navigator 2003 Owner's Manual page 414

Table of Contents

Advertisement

Chassis Information
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
1 0 • 4 1 4
Automatic Leveling
When set to auto-level, the system will attempt to level to the lowest point first.
Example: if the right rear is the low, the system will dump air from the front and left
rear air springs until the motorhome is level. If the air springs fully deflate before
the motorhome is level, the system will raise the entire motorhome and go through
another leveling process. It is critical there is no movement in the motorhome while
the system is attempting to auto-level.
To Level:
• Start the engine. The leveling system will operate faster if engine
is running.
• Set the parking brake.
• The transmission must be in neutral. (Important: Please no
movement in the motorhome while the system is leveling.)
• Press the AIR button once to enter air mode. The Air indicator
light and four yellow warning lights will glow steady.
• Press the AIR button a second time. The Air indicator light will
start flashing and automatic leveling will begin.
• When all four yellow lights are out, the leveling process is
complete. The Air indicator light will stop flashing and glow
steady. The engine may now be turned off.
NOTE: The control panel remains on until time of departure or
storage.
The control panel remains on and the Processor enters Sleep Mode. The
processor will continue to monitor the level sensors. When there is movement
in the motorhome, the yellow lights will blink, indicating an off-level condition.
If one or more yellow lights glow steady for more than one minute, the
processor will "awaken" and make any necessary adjustments to return the
motorhome to level. After any adjustments are made, the processor will go
back to Sleep. This will continue until the system is turned OFF, or the
transmission is placed in gear and the parking brake released.
NOTE: If the control panel is turned off, the Processor will not
make any adjustments and an off level condition may occur over
time.
N A V I G A T O R 2 0 0 3

Advertisement

Table of Contents
loading

Table of Contents