Table of Contents
Advertisement
8
Configuring the network drive
You will need the following data for configuring the network drive:
Name
Server IP address or host name
Shared folder
User name
Password
Network drive options
Requirement:
available.
Further information:
Further information:
Configuring the printer
The product can print measurement reports and stored PDF files with a printer
connected via USB or the network. The product supports several printer models
from various manufacturers. See the product area at
complete list of supported printers.
If this list contains the used printer, the appropriate driver is available on the
product and you can directly configure the printer. If this is not the case, you will
need a printer-specific PPD file.
Further information:
116
Contact your network administrator for the correct network settings for
configuring the product.
The product is connected to a network and a network drive is
"Connecting a network peripheral", Page 48
Tap Settings in the main menu
Tap Interfaces
Tap Network drive
Enter the network drive details
Confirm the entries with RET
Use the ON/OFF sliding switch to activate or deactivate Show
password
If required, select Network drive options
Select Authentication for encrypting the password in the
network
Configure the Mount options
Tap OK
Tap Mount
The connection to the network drive is established
"Network drive", Page 167
"Finding PPD files", Page 120
Setup | Single steps for setup
www.heidenhain.de
for a
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 12/2018
Advertisement
Table of Contents
