HEIDENHAIN GAGE-CHEK 2000 Operating Instructions Manual page 181

Settings | Axes
Parameter
Encoder model
Signal period
Output signals per revolution
Interpolation
Mechanical ratio
Reference marks
Terminating resistor
Error monitor
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 12/2018
Explanation
Connected encoder model
Settings:
Linear encoder: Linear axis
Angle encoder: Rotary axis
Angle encoder as linear encoder: Rotary axis is displayed as
linear axis
Default value: Depending on the connected encoder
For linear encoders
Length of a signal period
Setting range: 0.001 µm ... 1000000.000 µm
Default value: 20.000
For angle encoders and for display of a rotary axis as a linear axis
Number of output signals
Setting range: 1 ... 10000000
Default value: 18000
Interpolation value of the angle encoders and integrated interpo-
lation for the evaluation of the coded reference marks.
Settings:
None
2-fold
5-fold
10-fold
20-fold
50-fold
Default value: None
For display of a rotary axis as a linear axis:
traverse path in mm per revolution
Setting range: 0.1 mm ... 1000 mm
Default value: 1.0
Configuration of the Reference marks
Further information: "Reference marks (Encoder)", Page 182
Dummy load to avoid reflections
Settings: ON or OFF
Default value: ON
Monitoring of signal errors
Settings:
Off: Error monitoring not active
Frequency: Error monitoring of signal frequency
Default value: Frequency
A warning or error message is displayed if one of the
limit values for error monitoring is exceeded.
The limit values depend on the signal of the connected encoder:
Error message with frequency ≥ 5 MHz
11
181