Adjusting Settings In The Quick Access Menu - HEIDENHAIN GAGE-CHEK 2000 Operating Instructions Manual

Basic operation | Using the Inspector
Function element
6.11.3

Adjusting settings in the quick access menu

With the quick access menu, you can adjust the following settings:
Unit for linear values (Millimeters or Inch)
Unit for angular values (Radian, Decimal degrees or Deg-Min-Sec)
Setting the units of measure
Before you start measuring, you need to set the desired units of measure in the
Inspector's quick access menu.
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 12/2018
Short description
Manual output of measured values
Send measured values to computer; tapping starts the data
transfer according to the configuration
"Sending measured values to a
Further information:
computer", Page 145
Touch-probe triggered output of measured values
Send measured values to computer; tapping activates the
automatic output of measured values according to the
configuration; the data is transferred when the stylus is
deflected
"Sending measured values to a
Further information:
computer", Page 145
Continuous output of measured values
Send measured values to computer; tapping activates the
automatic output of measured values according to the
configuration; the data is transferred continuously at inter-
vals of approx. 200 ms
"Sending measured values to a
Further information:
computer", Page 145
Tap the Quick access menu in the Inspector
Select the desired Unit for linear values
Select the desired Unit for angular values
Tap Close to close the quick access menu
The selected units are displayed in the quick access menu
6
69