HEIDENHAIN GAGE-CHEK 2000 Operating Instructions Manual page 86

7
Configuring axes for encoders with TTL interface
86
The configuration procedure is the same for each axis. The following
section describes only the configuration of the X axis.
Tap Settings in the main menu
Tap Axes
Tap X or, if applicable, Not defined
If applicable, select the name of the axis in the Axis name
drop-down list
Tap Encoder
Specify the connection for the corresponding encoder in the
Encoder input drop-down list:
X21
X22
X23
Select the type of encoder in the Encoder model drop-down
list:
Linear encoder: Linear axis
Angle encoder: Rotary axis
Angle encoder as linear encoder: Rotary axis is
displayed as linear axis
Depending on the selection, enter further parameters:
For Linear encoder, enter the Signal period
(see " Linear encoders", Page 88)
For Angle encoder, enter the Output signals per
revolution (see "Angle encoders", Page 90)
For an Angle encoder as linear encoder, enter the
Output signals per revolution and the Mechanical ratio
Confirm the entry with RET
In the Interpolation drop-down list, select the type of
interpolation:
None
2-fold
5-fold
10-fold
20-fold
50-fold
Tap Reference marks
Select the reference mark in the Reference mark drop-down
list:
None: There is no reference mark
One: The encoder has one reference mark
Coded: The encoder has distance-coded reference marks
Reverse coded: The encoder has inverse-coded reference
marks
Commissioning | Steps for commissioning
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 12/2018