Table of Contents
Advertisement
Setup | Single steps for setup
Configuring an interface
In the product settings you configure the interface for data transfer to the
computer.
Further information:
Selecting a data format
By assigning a data format to the functions for the measured value output, you
specify the format in which the measured values will be sent to the computer. You
can use the Standard data format for this or you can create your own data format
(see "Creating your own data format", Page 130).
Selecting a data format
Further information:
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 12/2018
Tap Settings in the main menu
Tap Interfaces
Tap RS-232
Tap X32
The following settings are sent through the RS-232 adapter,
and can be adapted as needed for the receiver software:
Baud rate
Data bits
Parity
Stop bits
Flow control
"RS-232", Page 168
Tap Settings in the main menu
Tap Interfaces
Tap Data transfer
In the RS-232 drop-down list, select the type of interface
In the following drop-down lists you can choose a
separate data format for each function:
Data format for (manual) data transfer
Data format for TP-triggered data transfer
Data format for continuous data transfer
Each drop-down list contains the Standard and
MyFormat1 data formats, as well as all of your own
data formats.
In order to assign a data format to a function, select the
desired data format in the respective drop-down list
"Data transfer", Page 169
8
129
Advertisement
Table of Contents
