HEIDENHAIN GAGE-CHEK 2000 Operating Instructions Manual page 95

Commissioning | Steps for commissioning
Further information:
Measuring calibration data in .acf format
The manufacturer of the calibration standard usually provides you with the
calibration data and specifications about the deviations. To read the calibration data
into the product you must measure these in .acf format.
Open a new file in the text editor of your computer
Save the file under a unique name and the file extension *.acf
Measure the calibration data with tab stops separated according to the
following schema
Schema of the calibration data in .acf format
Unit of measure
Spacing of supporting points on the X
axis
Number of supporting points on the X
axis
X value of the first supporting point
X value of the second supporting point
...
X value of the last supporting point
Select either X or Y as the directional axis.
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 12/2018
Tap Select
The table of supporting points is imported
To manually adjust the table of supporting points, tap Table
of supporting points
Adjust the actual values of the axes
The start the teach sequence, tap Start
The teach sequence is started and the wizard is displayed in
the Measure menu
Follow the instructions of the wizard
Values measured in the teach sequence are adopted as
actual values in the table of supporting points
After the teach sequence is complete, the Measure menu
continues to be displayed
Recall the Nonlinear error compensation (NLEC) menu
Activate Compensation with the ON/OFF sliding switch
The error compensation is applied from the next
measurement
"Nonlinear error compensation (NLEC)", Page 176
Directional axis
Spacing of supporting points on the Y
axis
Number of supporting points on the Y
axis
Y value of the first supporting point
Y value of the second supporting point
...
Y value of the last supporting point
7
95