Axes; Reference Marks - HEIDENHAIN GAGE-CHEK 2000 Operating Instructions Manual

11

Axes

11.6
This chapter describes settings for configuring the axes and assigned devices.
11.6.1

Reference marks

Path:
Parameters
Reference mark search after
unit start
All users can cancel reference
mark search
Reference mark search
Reference mark search status
Stop of reference mark search
174
Not all of the described parameters and options may be available,
depending on the product version, configuration and the connected
encoders.
Settings ► Axes ► General settings ► Reference marks
Explanation
Setting for the reference mark search after unit start
Settings:
ON: The reference mark search must be performed after
startup
OFF: No prompt for a mandatory reference mark search is
displayed after startup of the product
Default value: ON
Specifies whether the reference mark search can be canceled by
all user types
Settings
ON: The reference mark search can be canceled by any user
type
OFF: The reference mark search can only be canceled by OEM
or Setup-user types
Default value: OFF
Start starts the reference mark search and opens the workspace
Indicates whether the reference mark search was successful
Display:
Successful
Unsuccessful
Indicates whether the reference mark search was canceled
Display:
Yes
No
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 12/2018
Settings | Axes