Table of Contents
Advertisement
Setup | Single steps for setup
Configuring the network
Network settings
Contact your network administrator for the correct network settings for
configuring the product.
Requirement:
Further information:
Further information:
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 12/2018
The unit is connected to a network.
"Connecting a network peripheral", Page 48
Tap Settings in the main menu
Tap Interfaces
Tap Network
Tap the X116 interface
The MAC address is detected automatically
Depending on the network environment, activate or
deactivate DHCP using the ON/OFF sliding switch
If DHCP is active, the network settings are obtained
automatically as soon as the IP address is assigned
If the DHCP is not active, enter the IPv4 address, IPv4
subnet mask and IPv4 standard gateway
Confirm the entries with RET
Depending on the network environment, activate or
deactivate IPv6 SLAAC with the ON/OFF sliding switch
If IPv6 SLAAC is active, the network settings are obtained
automatically as soon as the IP address is assigned
If IPv6 SLAAC is not active, enter the IPv6 address, IPv6
subnet prefix length and IPv6 standard gateway
Confirm the entires with RET
Enter the Preferred DNS server and, if required, the
Alternative DNS server
Confirm the entires with RET
The configuration of the network connection is applied
"Network", Page 166
8
115
Advertisement
Table of Contents
