HEIDENHAIN GAGE-CHEK 2000 Operating Instructions Manual page 83

Commissioning | Steps for commissioning
Activating the reference mark search
The product uses the reference marks to reference the machine table to the
machine, for example. If the reference mark search has been activated, a wizard
appears on startup of the product and asks the user to move the axes for the
reference mark search.
Requirement:
configured in the axis parameters.
The reference mark search does not need to be performed for serial
encoders with EnDat interface, because the axes are automatically
homed.
The automatic reference mark search on startup of the product can be
canceled depending on the configuration.
Further information:
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 12/2018
The installed encoders have reference marks that have been
"Reference marks (Encoder)", Page 182
Tap Settings in the main menu
Tap Axes
Open in the sequence
General settings
Reference marks
Use the ON/OFF sliding switch to activate Reference mark
search after unit start
The reference marks must be traversed every time the
product is started
The functions of the product will only be available after the
reference mark search has been completed
The Reference symbol stops blinking upon successful
completion of the reference mark search
Further information:
display", Page 66
"Operating elements of the position
7
83