Handling and Control
Powering Up
Powering Up
1. Plug the power plug of the incubator into a suitable protection-earthed AC power outlet.
In the display window on the front panel the readiness indicator icon (rightmost icon in
the status display area at D4 in
2. Keep the On/Off button depressed for two seconds.
An initialization routine will be run after the incubator has been powered up. On
completion of the initialization, the display will light up and the current work space
temperature will appear in the temperature display field (item D1 in
page
Switching the Incubator Off / Powering Down
1. Keep the On/Off button depressed for two seconds.
The display window goes out, except for the readiness indicator icon (rightmost icon in
the status display area at D4 in
readout in case the work space temperature is still higher than 50 °C (122 °F). The
incubator is switched off now.
2. If required, unplug the AC power plug to power down the incubator completely.
7-6
Heratherm
7-1). The incubator is ready for use now.
on
page
7-1) is illuminated.
figure 7-1
on
page
7-1) and a residual heat temperature
figure 7-1
figure 7-1
on
Thermo Scientific