Chapter 6 Operation; Preparing The Incubator; Starting Operation - Thermo Scientific Heratherm IMH 60 Operating Instructions Manual

Operation

Preparing the Incubator

The incubator must not be released for operation before all major start-up activities have been
completed (see
Device Check
Prior to starting operation, the following incubator components must be checked for their
correct function:
• The door seal in the front frame must not be damaged.
• The glass door must not be damaged.
• The shelving components must be installed safely.
• Disinfecting the Incubator's Work Space
Run the decontamination routine (Heratherm IMH 60/100/180/400/750-S devices only; see
section
operator-specified hygiene guidelines.

Starting Operation

1. Turn the incubator on using the control panel.
2. Adjust the temperature set value on the control panel.
3. Launch decontamination (optional with Heratherm IMH 60/100/180/400/750-S devices
only; see
4. The temperature controller starts adjusting the work space to the user-specified
temperature set value now.
Thermo Scientific
"Installation procedures"
"Decontamination" on
"Decontamination"
on page 5-1).
page 7-16) or disinfect the work space according to the
on page 7-16).
6
Heratherm 6-1