Mitsubishi Electric MELDAS C6 Interface Manual page 271

B con-
Signal name
tact
MANUAL RANDOM FEED
—
1ST AXIS VALID
[Function]
This signal is used to validate the axis specified by the "Manual random feed 1st axis number"
signal so that the axis component can move in manual random feed mode.
[Operation]
(1) The specification of the axis by the "Manual random feed 1st axis number" signal explained
earlier is validated only when the "CX1S" signal is turned ON.
[Related signal]
For related signal, see the section "Manual random feed mode (PTP)."
B con-
Signal name
tact
MANUAL RANDOM FEED
—
2ND AXIS NUMBER
[Function] [Operation]
See the descriptions on the "Manual random feed 1st axis number" signal (CX11~CX116)
explained above.
B con-
Signal name
tact
MANUAL RANDOM FEED
—
2ND AXIS VALID
[Function] [Operation]
See the descriptions on the "Manual random feed 1st axis valid" signal (CX1S).
B con-
Signal name
tact
MANUAL RANDOM FEED
—
3RD AXIS NUMBER
[Function] [Operation]
See the descriptions on the "Manual random feed 1st axis number" signal (CX11~CX116)
explained above.
B con-
Signal name
tact
MANUAL RANDOM FEED
—
3RD AXIS VALID
[Function] [Operation]
See the descriptions on the "Manual random feed 1st axis valid" signal (CX1S).
6. EXPLANATION OF INTERFACE SIGNALS
6.3 PLC Output Signals (Bit Type: Y***)
Signal
abbreviation
CX1S
Signal
abbreviation
CX21~CX216
Signal
abbreviation
CX2S
Signal
abbreviation
CX31~CX316
Signal
abbreviation
CX3S
6-3-74
1st system 2nd system
Y797 Y877
1st system 2nd system
Y798~79C Y878~87C
1st system 2nd system
Y79F Y87F
1st system 2nd system
Y7A0~7A4 Y880~884
1st system 2nd system
Y7A7 Y887
3rd system
Y957
3rd system
Y958~95C
3rd system
Y95F
3rd system
Y960~964
3rd system
Y967