Removing The Packing Material From The Dryer And The Shipping Screw - Kodak X-Omat 5000 RA PROCESSOR Installation Instructions Manual

Removing the Packing Material from the DRYER and the SHIPPING SCREW

H148_0116HCA
H148_0116HA
[1] Remove the packing material that holds the ends of the ROLLER ASSEMBLIES and AIR TUBES.
[2] Remove the front AIR TUBES and all the ROLLERS from the DRYER.
[3] Remove all the remaining packing material from the DRYER.
[4] Check that the back AIR TUBES are fully seated on both the drive and nondrive sides.
[5] Install the ROLLERS and front AIR TUBES.
[6] Check that the ROLLERS and the front AIR TUBES are fully seated on both the drive and nondrive sides.
5B6339 – January 1996
Preparing the PROCESSOR for Installation
AIR TUBE
ROLLER
ASSEMBLY
9