General Information; Electrostatic Discharge; Special Tools - Kodak X-Omat 2000 PROCESSOR Installation Instructions Manual

INSTALLATION INSTRUCTIONS
Section 1: General Information

Electrostatic Discharge

Electrostatic discharge (ESD) is a primary source of:
• product downtime
• low productivity
• costly repairs
While one cannot feel a static charge of less than 3,500 volts, as few as 30 volts can damage or destroy essential
components in electronic equipment.
Preventive Measures
• Always look for an ESD warning label before doing any procedure involving static-sensitive components such as
CIRCUIT BOARDS. All static-sensitive components are marked with bright graphic labels which frequently
include instructions. Follow all label instructions.
• Wear a GROUNDING STRAP when handling static-sensitive components. Always be sure that the CLIP remains
attached to a properly grounded, unpainted, clean surface.
• Repair static-sensitive components at an ESD-protected work station or use a portable GROUNDING MAT. For
help in setting up an ESD-protected work station, contact your Kodak representative.
• When moving static-sensitive components from one area to another, insert and transport the components in
ESD-protective packaging.

Special Tools

• AIR METER TL-2431
• LEVEL TL-1434
4 04DEC98 – 7C8771