Copying Or Confirming Si Data - Siemens SINUMERIK Series Function Manual

Commissioning - drive-based

3.5 Copying or confirming SI data

3.5 Copying or confirming SI data
As soon as the commissioning mode has been activated for a drive, the appropriate parameters
can be changed. The parameters are acquired for the first monitoring channel. Using the "Copy
SI data" function, the settings entered when commissioning are copied from the first into the
second monitoring channel. When exiting the commissioning mode normally, this function is
essentially automatically executed. However, it can also be manually initiated.
Copy SI data
Alternatively:
54
1. The commissioning mode is active. You wish to copy the SI data that has
been acquired from the first into the second monitoring channel.
Press the ">>" softkey to display the softkeys of the second vertical soft‐
key bar.
2. Press the "Copy SI data" softkey.
A prompt "Copy SI data" is then displayed.
Here, you can define whether the SI data should be only copied for the
actual drive - or for all of the available drives.
3. Press the "OK" softkey to activate the SI data for the actual drive.
- OR -
Press the "Copy all drives" softkey to copy the SI data of all the available
drives.
The SI data are copied from the first into the second monitoring channel.
A prompt is then displayed as to whether you wish to exit the commis‐
sioning mode. If you wish to remain in the commissioning mode, you can
close the prompt using the "Cancel" softkey.
You must confirm the SI data if you wish to exit the commissioning mode
here.
4. Press the "OK" softkey to confirm the SI data for the actual drive.
- OR -
Press the "Confirm all drives" softkey to confirm the SI data of all the
available drives.
The commissioning mode is exited.
Press the "Cancel" softkey.
Copying SI data is canceled.
Function Manual, 10/2015, 6FC5397-3EP40-5BA3
Safety Integrated