Technical Data And Drawings; Standards And Regulations; Table B-1 Standards And Regulations - Siemens SINAMICS SH150 Operating Instructions & Installation Instructions

Technical data and drawings

An overview of general and specific technical data of the device is provided in the following.
Further, you will find directives relating to the conditions that you must comply with when using
the described device.
Note
Finding technical data and drawings
You will find plant-specific information in the separate document "Technical data and drawings."
B.1

Standards and regulations

Standards and regulations
Table B-1
Standards
EU Directives
Insulation
Protection class
Touch protection
Emitted interference
SINAMICS SH150 6SL3805
Operating Instructions 05/2020
Standards and regulations
Standards and regulations
DIN EN 61800-5-1/VDE 0160 T105 (IEC 61800-5-1)
DIN EN 61800-3/VDE 0160 T103 (IEC 61800-3)
DIN EN 61800-4/VDE 0160 T104 (IEC 61800-4), however, only when refer‐
enced in the standards DIN EN 61800-3 or DIN EN 61800-5-1
DIN EN 60204-11/VDE 0113 T11 (IEC 60204-11)
2014/35/EU + amendments (Low Voltage Directive)
2014/30/EU + amendments (Electromagnetic Compatibility)
According to DIN EN 50178/VDE 0160 (IEC 62103), IEC 61800-5-1:
Pollution degree 2 (without conductive pollution), non-condensing
Class 1 according to DIN EN 61800-5-1/VDE 0160 T105 (IEC 61800-5-1)
DIN EN 50274/VDE 0660 T514 and BGV A3 when used for the intended
application
This drive unit is part of a PDS, Category C4 according to DIN EN 61800-3/
VDE 0160 T103 (IEC 61800-3). The drive unit has not been designed to be
connected to the public line supply. The equipment can cause electromag‐
netic interference when it is connected to the public network. The essential
requirements placed on EMC protection for the drive system should be se‐
cured using an EMC plan at the customer site.
B
121