Exit The Commissioning Mode - Siemens SINUMERIK Series Function Manual

4.4

Exit the commissioning mode

You can immediately exit the commissioning mode if no safety parameters were changed. If
safety parameters were changed, before exiting the commissioning mode, it still has to be
defined what should happen with the modified safety parameters.
Procedure
Safety Integrated
Function Manual, 10/2015, 6FC5397-3EP40-5BA3
1. You wish to exit the commissioning mode.
Press the "OK" softkey.
Based on the checksums, the program checks as to whether SI parame‐
ters were changed.
If this is not the case, then the following prompt is displayed:
Press the "OK" softkey.
The commissioning mode is exited here.
- OR -
If the program identifies that SI parameters were changed, then a prompt
is displayed:
Commissioning - TM54F
4.4 Exit the commissioning mode
99