Siemens SINUMERIK Series Function Manual page 96

Commissioning - TM54F
4.2 Activating the commissioning mode
96
Press the "OK" softkey.
There are several TM54F
4. If several TM54F are being used, additional softkeys are displayed where
you can set the required TM54F.
Press the "TM54F" softkey – and using the "TM54F+", or "TM54F-" soft‐
key, select the required terminal expansion module.
- OR -
Press the "Select TM54F" softkey.
This softkey is only visible if there are several TM54F devices are in your
drive system.
A selection of all of the TM54F devices that exist in the drive system is
displayed.
Select the required TM54F.
Press the "OK" softkey to complete the selection of the TM54F.
Press the "Change" softkey.
A prompt to activate the TM54F commissioning mode is displayed.
Press the "OK" softkey to activate the commissioning mode for the actual
TM54F.
- OR -
Press the "Activate all TM54F" softkey to activate the commissioning
mode for all TM54F in the drive system.
This softkey is only visible if there are several TM54F devices are in your
drive system.
The prompt is closed. The entry fields in the window are active.
- OR -
Press the "Cancel" softkey.
In this particular case, activating the commissioning mode is canceled.
Function Manual, 10/2015, 6FC5397-3EP40-5BA3
Safety Integrated