Table of Contents
Advertisement
DSA Keys
Use only SHA2
and Higher
Telnet
Enable Logins
Web Telnet
Timeout
Escape Sequence A single character or a two-character sequence that causes the SLB unit to terminate a
Outgoing Telnet
Web SSH/Web Telnet Settings
Terminal Buffer
Size
Phone Home
Enable
IP Address
Last Attempt
(view only)
Results
(view only)
3. To save, click the Apply button.
SLB™ Branch Office Manager User Guide
Enables or disables support for DSA keys for incoming and outgoing connections for
the StLB unit. Any imported or exported DSA keys will be retained but will not be visible
on the web or the CLI. Enabled by default.
Enables or disables support for only SHA2 and higher ciphers for incoming connections
for the SLC unit. Disabled by default. Enabling this option will also disable MACs with
tag sizes lower than 128 bits (e.g. umac-64-etm@openssh.com and umac-
64@openssh.com).
Enables or disables Telnet logins to the SLB branch office manager to allow users to
access the CLI using Telnet. Disabled by default.
This setting does not control Telnet access to individual device ports. (See
Ports - Settings (on page 113)
ports.) You may want to keep this option disabled for security reasons.
Enables or disables the ability to access the SLB command Iine interface or device
ports (connect direct) through the Web Telnet window. Disabled by default.
If you enable Telnet logins, you can cause an idle connection to disconnect after a
specified number of minutes. Select Yes and enter a value of from 1 to 30 minutes.
Note:
You must reboot the unit before a change will take effect.
Telnet client. Currently the Escape Sequence is only used for Web Telnet sessions.
The default value is Esc+T (escape key, then uppercase "T" performed quickly but not
simultaneously). You would specify this value as \x1bT, which is hexadecimal (\x)
character 27 (1B) followed by a T. A control character can be specified with the
hexidecimal number for the control character; for example, Control-E can be specified
as \x05. Note that some browsers do not report key press events if Control is pressed
for non-alphanumeric keys, so it is recommended to only use letters with Control
character sequences.
Enables or disables the ability to create Telnet out connections.
Number of lines in the Web SSH or Web Telnet terminal window that are available for
scrolling back through output.
If enabled, allows SLB branch office manager to directly contact a vSLM management
appliance and request addition to the database
IP address of the vSLM management appliance.
Displays the date and time of last connection attempt.
Indicates whether the attempt was successful.
for information on enabling Telnet access to individual
7: Services
Device
87
Advertisement
Table of Contents
