Table of Contents
Advertisement
Models
The SLB branch office manager has the following hardware components:
The 100-120 VAC SLB model is available in 100-120 VAC (50-60 Hz) NEMA 5-20R type
outlets. This model also includes a USB port.
The 200-240 VAC SLB model is available in 200-240 VAC (50-60 Hz) IEC C13 type outlets.
This model also includes a USB port.
Note:
Chassis: The SLB unit has a 1U tall, self-contained rack-mountable chassis.
Power Outlets: Eight outlets allow power management and control (on/off/reboot) of the
attached equipment using a simple web or command line interface.
Serial Device Ports: Eight serial RS-232C (EIA-232) device ports are for remote console
management of the attached equipment. These match the RJ45 pin-outs of the console ports
of many popular devices found in a network environment, and where different can be
converted using Lantronix adapters. See the appendix,
more information on serial adapters and pin-outs.
Ports and Modem: The SLB branch office manager has two 10/100 Ethernet ports (referred
to in this user guide as Eth1 and Eth2) in the back and a front panel serial console port (RJ45).
The SLB unit also includes a USB type A port in the front panel and an internal v.92 modem.
Model
100-120 VAC SLB
200-240 VAC SLB
SLB™ Branch Office Manager User Guide
This model is EU style with one switched hot line, not a US style with two hot
lines. It is intended for use on power systems where the 200-240VAC is provided
on a single hot line.
Table 2-2 SLB Models
Description
Branch Office Manager, 8 device ports, 8 power outlets (100-120 VAC, NEMA 5-
20R type), 2 AC power inlets
Branch Office Manager, 8 device ports, 8 power outlets (200-240 VAC, IEC C13
type), 2 AC power inlets
Figure 2-3 100-120 VAC SLB Unit
Appendix C: Adapters and Pinouts
2: Introduction
for
23
Advertisement
Table of Contents
