Table of Contents
Advertisement
1. Open a web browser.
2. In the URL field, type https:// followed by the IP address of your SLB branch office
manager.
3. To configure the SLB unit, use sysadmin as the user name and PASS as the password.
(These are the default values.)
Note:
The system administrator may have changed the password using one of the
Quick Setup methods in the previous chapter.
The Lantronix SLB
Subsequently, the Lantronix SLB Home page displays. (If you want to display the
page again, click Quick Setup on the main menu.)
Logging Out
To log off the SLB web interface:
1. Click the Logout button located on the upper left part of any user interface page. You are
brought back to the login screen when logout is complete.
Web Page Help
To view detailed information about an SLB web page:
1. Click the Help button to the right of any user interface page. Online Help contents will appear
in a new browser.
Command Line Interface
A command line interface (CLI) is available for entering all the commands you can use with the
SLB. In this User Guide, after each section of instructions for using the web interface, you will find
the equivalent CLI commands. You can access the command line interface using Telnet, SSH, or
a serial terminal connection.
Note:
By default, Telnet is disabled and SSH is enabled. To enable Telnet, use the
Services > SSH/Telnet/Logging
connection. (See
The sysadmin user and users with who have full administrative rights have access to the complete
command set, while all other users have access to a reduced command set based on their
permissions.
Logging In
To log in to the SLB command line interface:
1. Do one of the following:
With a serial terminal connection, power up, and when the command line displays, press
Enter.
SLB™ Branch Office Manager User Guide
Quick Setup
page displays automatically the first time you log in.
web page, a serial terminal connection, or an SSH
Chapter 7:
Services.)
5: Web and Command Line Interfaces
Quick Setup
54
Advertisement
Table of Contents
