Rule Parameters; Figure 6-4 Network > Ip Filter Ruleset (Adding/Editing Rulesets) - Lantronix 100-120 VAC SLB User Manual

Rulesets can be added or updated on this page.
2. Enter the following:
Ruleset Name

Rule Parameters

IP Address(es)
Subnet Mask
Protocol
SLB™ Branch Office Manager User Guide
Figure 6-4 Network > IP Filter Ruleset (Adding/Editing Rulesets)
Name that identifies a filter; may be composed of letters, numbers, and hyphens
only. (The name cannot start with a hyphen.)
Example: FILTER-2
Specify a single IP address to act as a filter.
Example:
172.19.220.64
Specify a subnet mask to act determine how much of the address should apply to
the filter.
Example:
255.255.255.255
From the drop-down list, select the type of protocol through which the filter will
operate. The default setting is All.
– this specific IP address only
to specify the whole address should apply.
6: Basic Parameters
67